Listen to Radio
Comfort controls 7-27
Press the RADIO key to switch the band.
Switch between AM and FM bands.
The selected band is indicated on the display.
*: When a satellite tuner is connected
Turn the /SEL key to the frequency to lis-
ten to.
Collective search for stations that can be
received.
Press the SCAN key.
When a station is received, this is played for 5
seconds, then the product searches for the
next station.
Register the broadcast station in advance, and
select this at a later time.
1. Tune in to the frequency to register.
2. Hold down any of the keys from the 1RPT
key to the 6 key.
A “Beep” sounds, and the preset key is
registered.
During RBDS broadcast reception, select
CAT (category content), and automatically
scan for stations.
1. During FM reception, press the CAT key.
This switches to the CAT selection mode.
2. Press the CAT key to select CAT.
3. Press the key or key.
The CAT (category content) indicator will
flash, and station selection will automati-
cally start.
When a station is received, the frequency
is displayed.
To Listen to the Radio
Bands switch in the order AM, FM1, FM2,
SIR1*, SIR2*, SIR3*, and SIR4*.
If no signal is received, bands will not be
switched to SIR2, SIR3, or SIR4.
Manual/Seek Station Selection
/SEL key
(counter-
clockwise)
Reduces the frequency
being received.
/SEL key
(clockwise)
Increases the frequency
being received.
key
(hold down)
Release the button to start
seek station selection, and
when a station is received,
scanning stops.
key
(hold down)
Scan Station Selection
Press this button again while receiving the
station to return to normal reception.
Preset Memory
The preset memory can register a maximum
of 6 stations for each band.
If a preset key that already has a station reg-
istered is selected, then this is overwritten
with the new preset.
Pressing the preset key will select the previ-
ously registered frequency.
CAT Search
This receives the station detected first.
BK0239700US.book 27 ページ ２０１６年６月１６日 木曜日 午前１０時５８分
To Next Page
Loading...
