Making a cargo area
Seat and restraint systems 4-15
1. Raise the seatback until it locks securely
into place.
2. While lifting the seat belt buckle (A), gen-
tly lower the seat cushion. Make sure that
there is a hook (B) at the position shown
in the illustration.
3. Push down the seat cushion until it locks
securely into place.
4. Make sure that all seat belt buckles are
properly positioned on the seat cushion.
5. Return the folded head restraint to its
original position.
6. If the center seat belt is stored;
• Pull out the detachable anchor plate (D)
from the seatback.
• Pull the small latch plate (E) slowly and
insert it into the detachable anchor plate
until a click is heard.
• Make sure that the seat belt is not
twisted.
For details, refer to “Detachable center
seat belt for second row” on 4-21.
To ret urn
A rubber strap (C) is attached to the seat belt
buckle for the left outboard seating position.
This helps raise the seat belt buckle while the
seat cushion returns to the original position.
Ensure that the head restraints are
returned to their original positions before
the seats are occupied. Failure to do so
could cause serious injury if involved in an
accident.
BK0239700US.book 15 ページ ２０１６年６月１６日 木曜日 午前１０時５８分
To Next Page
Loading...
Need help?
General
