Keyless entry system (if so equipped)
5-10 Features and controls
N00543701060
If you are near your vehicle and feel threat-
ened, you may activate the alarm to call atten-
tion as follows:
1. Press the PANIC button (3) for more than
1 second.
2. The headlights will blink on and off and
the horn will sound intermittently for
about 3 minutes.
3. To turn off the alarm, press any button on
the remote control transmitter.
N00543801087
Only remote control transmitters pro-
grammed with the vehicle’s electronics can
lock or unlock all doors and the liftgate.
If you lose the remote control transmitter, you
can order a remote control transmitter from
your authorized Mitsubishi Motors dealer by
referring to the key number.
To prevent vehicle theft, the ID code for the
remote control transmitter must be changed.
Take your vehicle and all remote control
transmitters to your authorized Mitsubishi
Motors dealer to have your ID code changed.
N00543900049
To add a remote control transmitter, you must
already have 1 registered remote control
transmitter.
Registering the ID code can be done by your-
self or by your authorized Mitsubishi Motors
dealer. For you to register the ID code your-
self, follow the “Customer remote control
transmitter programming” procedure below.
If you choose to have your authorized
Mitsubishi Motors dealer register the ID
code, take your vehicle and any remaining
keys to your authorized Mitsubishi Motors
dealer.
N00544001190
You can program new remote control trans-
mitters to the system if you have one valid
(already registered) remote control transmit-
ter by doing the following:
1. Have available all (current and new)
remote control transmitters you wish to
register.
2. With a valid (already registered) remote
control transmitter, press the UNLOCK
button (2) for 4 to 10 seconds. Then press
and hold the LOCK button (1).
3. Within 10 seconds of pressing the LOCK
button, release the LOCK and UNLOCK
buttons in sequence.
At this time, ID codes for all remote con-
trol transmitters except for the transmitter
used in steps 2 and 3 are erased and the
answerback function (door is locked and
unlocked) informs you that the registra-
tion mode has been activated.
4. Within 60 seconds after step 3, complete
the following ID code registration opera-
tion using the next remote control trans-
mitter you wish to register within 4
seconds.
On a vehicle equipped with a Mitsubishi
Multi-Communication System, the functions
can be adjusted on the screen. For details,
refer to the separate operation manual.
Using the panic alarm
Replacement remote control
transmitters
Additional remote control
transmitters
You are provided with 2 remote control
transmitters, but you may register up to 8
remote control transmitters.
Customer remote control trans-
mitter programming (Except
for vehicles sold in Canada)
BK0239700US.book 10 ページ ２０１６年６月１６日 木曜日 午前１０時５８分
To Next Page
Loading...
