Screen Cause Solution (Reference)
l
There is a fault in the sensor.
l
We recommend you to contact a
MITSUBISHI MOTORS Authorized
Service Point.
Refer to “Forward Collision Mitigation
System (FCM): When a problem is detec-
ted” on page 7-73.
Refer to “Lane Departure Warning
(LDW): System problem warning” on
page 7-90.
Refer to “Automatic High-Beam (AHB):
System problem warning” on page 6-64.
l
The Forward Collision Mitigation System
(FCM), Lane Departure Warning (LDW)
and Automatic High-Beam (AHB) are
temporarily unavailable due to the high or
low temperature of the sensor.
l
After the temperature of the sensor has
been in range, the system will automati-
cally return to operation.
Refer to “Forward Collision Mitigation
System (FCM): When a problem is detec-
ted” on page 7-73.
Refer to “Lane Departure Warning
(LDW): System problem warning” on
page 7-90.
Refer to “Automatic High-Beam (AHB):
System problem warning” on page 6-64.
l
The sensor is temporarily unavailable due
to conditions such as the adhesion of con-
taminants to the sensor or windscreen.
This is not a malfunction.
Refer to “Forward Collision Mitigation System
(FCM): When a problem is detected” on page
7-73.
Refer to “Lane Departure Warning (LDW):
System problem warning” on page 7-90.
Refer to “Automatic High-Beam (AHB): Sys-
tem problem warning” on page 6-64.
Indication lamp, warning lamp, and information screen display list
6-46
OGGE19E1
Instruments and controls
6
To Next Page
Loading...
