Mitsubishi Q01CPU User Manual

12
TROUBLESHOOTING
12.3 Error Code List
12.3.3 Error code list (1000 to 1999)
12 - 87
9
EMC AND LOW VOLTAGE DIRECTIVES
10
LOADING AND INSTALLATION
11
MAINTENANCE AND INSPECTION
12
TROUBLESHOOTING APPENDICES INDEX
1520
The voltage(100 to 240VAC) of the
power supply module on the extension
base unit dropped to or below 85% of
the rated voltage.
(This can be detected from the control
system of the stand-alone system or
redundant system.)
Check the supply voltage of the power
supply module. If the voltage is
abnormal then replace the power supply
module.
Q4AR
On the redundant base unit, the one
damaged redundant power supply
module was detected.
Hardware fault of the redundant power
supply module. (Contact your local
Mitsubishi representative, explaining a
detailed description of the problem.)
Qn(H)
*6
QnPH
*6
QnPRH
QnU
*13
Rem
1530
The 24 VDC power supplied to the
system management module AS92R
has dropped below 90% of the rated
voltage.
(This can be detected from the control
system or standby system of the
redundant system.)
Check the 24VDC power supplied to the
system management module AS92R.
Q4AR
1600
• The battery voltage in the CPU
module has dropped below stipulated
level.
• The lead connector of the CPU
module battery is not connected.
• Change the battery.
• If the battery is for program memory,
standard RAM or for the back-up
power function, install a lead
connector.
1601
Voltage of the battery on memory card 1
has dropped below stipulated level.
Change the battery.
QnA
Qn(H)
QnPH
QnPRH
QnU
1602
Voltage of the battery on memory card 2
has dropped below stipulated level.
Change the battery. QnA
1610
The number of writing to flash ROM
(standard ROM and system securement
area) exceeds 100,000 times.
(Number of writings >100,000 times)
Change the CPU module. QnU
Error
Code
(SD0)
Error Contents and Cause Corrective Action
Corresponding
CPU
*4 Function version is B or later.
*5 Function version is A.
*6 The module whose first 5 digits of serial No. is 04101 or later.
*7 The module whose first 5 digits of serial No. is 07032 or later.
*8 The module whose first 5 digits of serial No. is 08032 or later.
*9 The module whose first 5 digits of serial No. is 09012 or later.
*10 The Universal model QCPU except the Q02UCPU.
*11 The Q13UDHCPU and Q26UDHCPU
*12 This applies to the QnUDE(H)CPU.
*13 The module whose first 5 digits of serial No. is 10042 or later.

Mitsubishi Q01CPU Specifications

General

Brand	Mitsubishi
Model	Q01CPU
Category	Controller
Language	English