12
TROUBLESHOOTING
12.3 Error Code List
12.3.4 Error code list (2000 to 2999)
12 - 123
9
EMC AND LOW
VOLTAGE
DIRECTIVES
10
LOADING AND
INSTALLATION
11
MAINTENANCE AND
INSPECTION
12
TROUBLESHOOTING APPENDICES INDEX
2401
Program memory capacity was
exceeded by performing boot operation
or automatic write to standard ROM.
• Check and correct the parameters
(boot setting).
• Delete unnecessary files in the
program memory.
• Choose "Clear program memory" for
boot in the parameter so that boot is
started after the program memory is
cleared.
Qn(H)
*3
QnPH
QnPRH
Program memory capacity was
exceeded by performing boot operation.
QnU
The file specified by parameters cannot
be made.
• Read the individual information of the
error using the peripheral device,
check to be sure that the parameter
drive name and file name correspond
to the numerical values there
(parameter number), and correct.
• Check the space remaining in the
memory card.
Although setting is made to use the
device data storage file, there is no
empty capacity required for creating the
device data storage file in the standard
ROM.
Secure the empty capacity of the
standard ROM.
QnU
2402
Though the file register has been set in
the pairing setting/tracking setting, the
file register does not exist.
Confirm the file register and parameter. Q4AR
2410
• The specified program does not exist
in the program memory.
This error may occur when the
ECALL, EFCALL, PSTOP, PSCAN,
POFF or PLOW instruction is
executed.
• The specified file does not exist.
• Read the individual information of the
error using the peripheral device,
check to be sure that the program
corresponds to the numerical values
there (program location), and correct.
Create a file created using
parameters, and load it to the CPU
module.
• In case a specified file does not exist,
write the file to a target memory and/
or check the file specified with the
instruction again.
QnA
Qn(H)
QnPH
QnPRH
QnU
Error
Code
(SD0)
Error Contents and Cause Corrective Action
Corresponding
CPU
*3 The function version is B or later.
*4 The function version is A.
*5 The module whose first 5 digits of serial No. is 04101 or later.
*6 The module whose first 5 digits of serial No. is 09012 or later.
*7 The Universal model QCPU except the Q02UCPU.
*8 This applies to the QnUDE(H)CPU.
*9 The module whose first 5 digits of serial No. is 10042 or later.
To Next Page
Loading...
Need help?
General
