12
TROUBLESHOOTING
12.3 Error Code List
12.3.6 Error code list (4000 to 4999)
12 - 163
9
EMC AND LOW
VOLTAGE
DIRECTIVES
10
LOADING AND
INSTALLATION
11
MAINTENANCE AND
INSPECTION
12
TROUBLESHOOTING APPENDICES INDEX
*3 The module whose first 5 digits of serial No. is 04012 or later.
*4 The module whose first 5 digits of serial No. is 07012 or later.
*5 The module whose first 5 digits of serial No. is 07032 or later.
*6 The module whose first 5 digits of serial No. is 09012 or later.
*7 The Universal model QCPU except the Q02UCPU.
*8 This applies to the QnUDE(H)CPU.
4100
The instruction cannot process the
contained data.
Read the common information of the
error using the peripheral device, check
error step corresponding to its
numerical value (program error
location), and correct the problem.
Rem
Access error of ATA card occurs by
FREAD/FWRITE instructions.
• Take measurements against noise.
• Reset and restart the CPU module.
When the same error is displayed
again, the ATA card has hardware
failure.
(Please consult your local Mitsubishi
service center or representative,
explaining a detailed description of
the problem.)
Qn(H)
QnPH
QnPRH
The file being accessed by other
functions with FWRITE instruction was
accessed.
• Stop the file accessed with other
functions to execute FWRITE
instruction.
• Stop the access with othrer functions
and the FWRITE instructuion to
execute at same time.
QnU
*8
Error
Code
(SD0)
Error Contents and Cause Corrective Action
Corresponding
CPU
To Next Page
Loading...
Need help?
General
