Mitsubishi Q01CPU User Manual

12
TROUBLESHOOTING
12.3 Error Code List
12.3.8 Error code list (6000 to 6999)
12 - 193
9
EMC AND LOW VOLTAGE DIRECTIVES
10
LOADING AND INSTALLATION
11
MAINTENANCE AND INSPECTION
12
TROUBLESHOOTING APPENDICES INDEX
6001
In a redundant system, the valid
parameter drive settings (SW2, SW3)
made by the DIP switches are not the
same.
Match the valid parameter drive settings
(SW2, SW3) by the DIP switches of the
control system and standby system.
QnPRH
6010
The operational status of the control
system and standby system in the
redundant system is not the same.
(This can be detected from the standby
system of the redundant system.)
Synchronise the operation statuses of
the control system and standby system.
Q4AR
The operational status of the control
system and standby system in the
redundant system is not the same.
(This can be detected from the standby
system of the redundant system.)
Synchronise the operation statuses of
the control system and standby system.
QnPRH
6020
At power ON/reset, the RUN/STOP
switch settings of the control system
and standby system are not the same in
a redundant system.
(This can be detected from the control
system or standby system of the
redundant system.)
Set the RUN/STOP switches of the
control system and standby system to
the same setting.
6030
• In a redundant system, the module
configuration differs between the
control system and standby system.
• The network module mode setting
differs between the two systems.
(This can be detected from the control
system or standby system of the
redundant system.)
• Match the module configurations of
the control system and standby
system.
• In the redundant setting of the
network parameter dialog box, match
the mode setting of System B to that
of System A.
6035
In a redundant system, the CPU module
model name differs between the control
system and standby system.
(This can be detected from the standby
system of the redundant system.)
Match the model names of the control
system and standby system.
Error
Code
(SD0)
Error Contents and Cause Corrective Action
Corresponding
CPU
*1 The module whose first 5 digits of serial No. is 09012 or later.

Mitsubishi Q01CPU Specifications

General

Brand	Mitsubishi
Model	Q01CPU
Category	Controller
Language	English