7 - 14 7 - 14
MELSEC-Q
7 FUNCTION
(3) Precautions
(a) Take note of the following, because STOP has priority in High Performance
model QCPU:
1) The High Performance model QCPU enters the STOP status when
remote STOP is performed from remote RUN contact, GX Developer,
or by using serial communication module.
2) To set the High Performance model QCPU to RUN status from STOP
status again, perform the remote RUN from the external factor (remote
RUN contact, GX Developer, serial communication module, etc.) from
which the remote STOP was performed.
REMARK
The RUN/STOP status is described below:
• RUN Status ...............Status in which the calculations are repeatedly executed
from step 0 to the END/FEND instruction in the sequence
program.
• STOP Status .............Status in which the sequence program calculations are
stopped and the output (Y) is all OFF.
To Next Page
Loading...
Need help?
General
