２ Rob ot arm
Definition of specifications
2-12
(2) About the use with the bad environment
This robot has protection methods that conform to IEC's IP65(all axis) standards (splashproof type). It has pro
-
tection structure designed to prevent harmful effects caused by splashing water coming from various directions,
as the robot is operating. Recommended usage conditions.
1) The robot is designed for use in combination with machining device.
2) Please examine cutting oil referring to Table 2-3 used by a standard examination of our company.
3) Take measures so that the robot will not be exposed to water, oil and/or chips for a long period of time.
The warranty is invalid for any faults that occur when the robot is used under the following conditions.
Also, if the cover and/or other parts are damaged by interferences caused by the peripheral devices and the
robot, the protection specification (seal performance, etc.) may be degraded. Therefore, please pay extra attention
when handling the robot.
Refer to Page 99, "6.2 Working environment".
1) In surroundings that generate inflammable gases or corrosive gasses.
2) Atmosphere used excluding cutting oil shown in Table 2-3
3) Environment where the robot is exposed to water, oil and/or chips for a long period of time.
4) In surroundings where chips fall directly on the robot.In surroundings where the minimum diameter of chips
is less than 0.5mm.
5) Mist atmosphere exceeding the specification.
6) Pressurization by the dry air exceeding the specification of Table 2-5
To Next Page
Loading...
Need help?
General
