Mitsubishi S4E - Page 107

(6) Remove two boiL< (II) securing elbow (12), and
t ake off Ulermo".t (13), as outlined pr< vi ously.
~
~ l1 -Bolt and w as hor
, ~ .J (2 pc:s e.oJ::h j
' 2 ~ Th errno st at el bO\o'V
1 3· Th ermos t at
Removing thermostat
InstaUiltion is reve r se of removal and can be effected by
CBrrying out the foregoing steps in t he reve rs e o rder.
After installing the water pump , be Surt to adjus.t the
bell ror proper tension.
[N OT El
Handle 'he fan be lt with car<, keeping it free of
iifly gr easy stain s. After removing the water
pump from the c ra nkcase, be su re to clos e the:
w ater opening of crankcase to 'C':void e!1 try of
dirt ,
Water pump disassembly
1-6 011
:2 -Cover
3-lm " .lIor
.J\
~~\\
\ \ \ (j)
\ \ ® ®
@®
6 -S n al'! r ing
7 .Se:a ri ng
8-Sh. ft
4-Unit Jel l 9-Boaring
s- on SCl i!ll lO · Pu mp CfI~e
Water p ump - Ex ploded view
(I) Remove co>,er (2), wruch is secured to the pump
case by boll, (1).
DISASSEMBLY AND RE A SS EMBLY
\
" /
"\
\
\'-y)..)
(2)
1·80 1l an.d washor 2-Cove.
Remoyjng pump COYer
Hold 'he pump "'a ft rigidl y, and unScrew pump
i
mp elle, (3) LO remOve it from the shafl.
JJGt1 1
Impeller (l) Is mOU!'.Ited lhutadlldlv on the shaft, Th e
screw th rum. lsoi righc-tlsnd S C;;I'1IIIII. T Cl remO\l1!' i mp.!! e ~ ,
tur n It in th e direction of the al l OW .
Remoying im pelle r
(3) Ease out oil seal (5) from pump case (10).
5.Qil sa l
Removing oil seal
n un-
( 4) U~ng pl iers, pick out , nap ring (6) from ",ound
lhe shaft.
101