Chapter Two: Installation How To Un
ack the T
e 246 Unit
19
Chapter Two: Installation
How To Unpack the Type 246 Unit
MKS has carefully packed the Type 246 unit so that it will reach you in perfect operating order.
Upon receiving the unit, however, you should check for defects, cracks, broken connectors, etc.,
to be certain that damage has not occurred during shipment.
Note
Do
not
discard any packing materials until you have completed your
inspection and are sure the unit arrived safely.
If you find any damage, notify your carrier and MKS immediately. If it is necessary to return the
unit to MKS, obtain an ERA Number (Equipment Return Authorization Number) from a MKS
Service Center before shipping. Please refer to the inside of the back cover of this manual for a
list of MKS Calibration and Service Centers.
Caution
Only qualified individuals should perform the installation and any
user adjustments. They must comply with all the necessary ESD and
handling precautions while installing and adjusting the instrument.
Proper handling is essential when working with all highly sensitive
precision electronic instruments.
Unpacking Checklist
Standard Equipment:
•
Type 246 Unit
•
Type 246 Instruction Manual (this book)
•
Power cord
Optional Equipment:
•
Electrical Connector Accessories Kit - 246C-K1
•
Mounting Accessories
Half-Rack Main Frame 246MF-1
Full-Rack Main Frame 246MF-2
Blank Panel 246P-1
•
Interface Cables (refer to Table 5, page 20)
To Next Page
Loading...