Chapter Two: Installation Interface Cables
15
Interface Cables
As of January 1, 1996, most products shipped to the European Community must comply with the
EMC Directive 89/336/EEC, which covers radio frequency emissions and immunity tests. In
addition, as of January 1, 1997, some products shipped to the European Community must also
comply with the Product Safety Directive 92/59/EEC and Low Voltage Directive 73/23/EEC,
which cover general safety practices for design and workmanship. MKS products that meet
these requirements are identified by application of the CE Mark.
To ensure compliance with EMC Directive 89/336/EEC, an overall metal braided shielded cable,
properly grounded at both ends, is required during use. No additional installation requirements
are necessary to ensure compliance with Directives 92/59/EEC and 73/23/EEC.
Note
1. An overall metal braided, shielded cable, properly grounded at both
ends, is required during use to meet CE specifications.
2. To order an overall metal braided shielded cable, add an “S” after the
cable type designation. For example, to order a cable to connect an
MKS controller, use part number CB652-1-XX, where XX designates
the cable length; for a braided, shielded cable use part number
CB652S-1-XX.
Interface Cables
MKS Controller Cable Number
651, 1651, 652 (Rev B or later) CB652-1-xx, CB652S-1-xx
where X indicates the length of the cable, in feet
Table 7: Interface Cables
To Next Page
Loading...
