Fig. 23
(1) Colour profi le setting.
(2) Volume level setting.
(3) Acoustic indication options.
8.3.5 DEVICE MAINTENANCE MENU
Fig. 24
8.3.5.1 SINGLE DEFROSTING
→ Defrosting
It is suitable to use single defrosting mainly in programs
with long-term intensive cooling, when the condensate
gets frostbitten in the chamber and on the cooling system
of the device. In the course of single defrosting, the forst is
effi ciently removed. The operation cannot be activated when
(1) (2)
(3)
the program is running. Defrosting is ctivated in the device
maintenance menu.
Warning:
In case of single defrosting the temperature in the
chamber of the device increases to 50 °C, so take the
tested samples out of the incubator so as to avoid their
damage.
Note:
It is necessary to distinguish between automatic defrosting
of cooling system (see 8.4.3) and single defrosting of the
whole device. Automatic defrosting removes icing from the
cooling system of the device only (and so it increases its
effi ciency) and it is performed automatically in the course of
the program operation. Single defrosting removes icing from
the whole device and it cannot be run while the rpogramn is
running.
Fig. 25
(1) Defrosting program parameters.
(2) Warning regarding objects that must be taken out of
the device.
- This option must be ticked, otherwise it is not
possible to start the program.
(3) Defrosting program start.
8.3.5.2 DECONTAMINATION
→ Decontamination
In the course of decontamination, the operation space of the
chamber faces high temperature. The initial parameters for
exposition are 160 °C and 30 minutes. These values may
be adjusted according to client´s requirements (a service
intervention is necessary).
(1)
(2)
(3)
Instructions for use
CLIMACELL EVO_np_en_1401_mmm_V1.01 19
To Next Page
