www.mobotix.com • sales@mobotix.com
The pre-installed cable attached to the camera
The pre-installed cable attached to the camera
must be connected with the on-site network cable. For installation without acces-
must be connected with the on-site network cable. For installation without acces-
sories, a flush-mounted socket must be installed first to provide space for the con-
sories, a flush-mounted socket must be installed first to provide space for the con-
nection. The cabling is now perfectly protected and cannot be seen or accessed
nection. The cabling is now perfectly protected and cannot be seen or accessed
from the outside. The camera cannot be mounted directly on top of protruding,
from the outside. The camera cannot be mounted directly on top of protruding,
surface-mounted sockets. Use the supplied camera drilling template (fold-out at
surface-mounted sockets. Use the supplied camera drilling template (fold-out at
the end of this manual) to mark the position of the flush-mounted socket for the
the end of this manual) to mark the position of the flush-mounted socket for the
Dri l l the h o les for the supp l ied screw anchors (se e dri l l ing tem p l a te).
Connect the on-site network cable to the camera patch cable
using a standard connector.
Use the (included) screws to ax the mounting ring and the
camera at the designated position.
he outer shell is required at a later stage in the installation and is attached only
when the dome has been removed and placed back after a lens adjustment.
roceed to Section 2.11, Aiming And Adjusting The Lens.
To Next Page
Loading...
