EXACTA
23
INSTALLATION AND TRANSPORT
Connect the side jack to a serial port of the PC
(COM1 ÷ COM4) by using a serial cable headed
autoclave side with a jack plug (this cable is
supplied as option).
By using the PC and the special application
software supplied by M.O.COM., the user will
be able to control all the features of the auto-
clave, directly program the cycles, monitor the
correct operation, have a complete information
about the alarms and the wear and tear of criti-
cal components in order to foresee the service
and reduce at minimum the “machine off line”.
Besides, by using a modem and the link with a
M.O.COM. service center, it will be possible to
carry out a remote diagnosis and adjust the pa-
rameters on the microprocessor logic.
Take off the wrapping from the filter and screw
it on the front joint of the autoclave.
The lifting the autoclave needs two peoples and
a trolley for the transport.
In case of transport or shipping, please use the
original packing.
THE AUTOCLAVE MUST BE TRANSPORTED AND
STORED AT A TEMPERATURE HIGHER THAN
0°C. A LENGTHY EXPOSURE AT LOWER TEM-
PERATURE CAN CAUSE DEMAGES TO THE MA-
CHINE.
To Next Page
Loading...
