Mocom Exacta - Page 38

EXACTA
30
READY indicates that the equipment is ready
to start a cycle; the LED is off if the in-
ternal autotest has detected a func-
tional anomaly (e.g. lack of distilled
water).
STER. “On” if the selected program is sterili-
zation type. The LED is flashing at the
end of the cycle to signalize that the
sterilization process has been correct-
ly executed. On the contrary the LED
is off (after the END message) and the
cycle must be repeated.
DIS. “On” if the program selected is disin-
fecting type. The LED is flashing at the
end of the cycle to signalize that the
disinfecting process has been correct-
ly executed. On the contrary the LED
is off (after the END message) and the
cycle must be repeated.
DRY “On” during the vacuum drying phase
and pressure leveling phase.
The display reports:
– at open and close door (before the
START command) the temperature of
the selected program (°C) and the
chamber temperature (°C);
– as the cycle starts, the current tem-
perature value (°C) in the chamber;
– message Off if the electronic circuit
has been switched off with the
ON/OFF key;
– message End at the end of the cycle
to signalize that the door may be
opened and the load recovered.
Moreover, as the program proceeds, a flashing
spot at the right of the display signalizes that
the heating resistance is functioning.