EXACTA
38
Use this key to jump the vacuum phase during
the standard or programmable cycle in order to
reduce the total process time. This Dry Off
function may be enabled before starting a cy-
cle. As the function enabled, the relating LED
flashes. This function is not allowed for liquid
programs.
This key is also used as software key to select
105°C, FAST and special programs.
The key is used to enable the microprocessor
control; consequently the front panel signaling
switches-on.
Pressing the key a next time, the microproces-
sor control will be disabled and the Tempera-
ture display shows the message Off.
The key is also used to exit date/time and spe-
cial cycle programming function.
ALARM LED switches on in case of general fail-
ure or operator’s error; this signaling is normal-
ly associated with an error code (e.g. F1-F2-F6-
A2 .....) on the timer display
In rest condition and without any entries on the
front panel for more than 30 minutes, the elec-
tronic circuit power supply will be automatically
shut off and consequently the front panel disa-
bled.
The temperature display will show the message
Off.
To enable again the front panel and select a
new cycle, press one time the ON/OFF key.
To Next Page
Loading...
