Creating the project
7
05/01 AWB27-1302-GB
The driver you have selected will be displayed on the
status bar at the bottom of the screen.
왘 Under ‹ Project
➞
Controller Setup...› select the
PLC with which you want to run the MI4, e.g. the
PS4-141-MM1
왘 Set the communication buffer size for input and
output at 20. These settings must agree with
those that you make later in the Sucosoft S40
Topology Configurator.
Under Panel ID the slave number is entered:
Slave 1 in this instance.
Following these preliminary settings the configurator
will present a display field on the screen which
corresponds to the MI4 display.
You can increase or decrease the size of the display
field by clicking on the following icons:
Zoom in
Zoom out
To Next Page
Loading...
