Creating and transferring
the PLC test program
39
05/01 AWB27-1302-GB
The MI4 switches to Configuration mode and is now
ready to transfer the project data.
왘 Click on the Download icon to start transmission.
Download
The project is now transferred to the MI4. Following
successful transfer the MI4 display will show a
diagram similar to the graphic on Page 27. The only
thing still missing is the touch cell “Page 2” which is
not created until the following expansion of the
example.
Creating and
transferring the
PLC test program
To be able to test the MI4 project the PLC must be
connected and a test program started on the PLC.
왘 Start Sucosoft S40.
왘 Open a new project and switch to the Topology
Configurator.
왘 Declare the MI4-471-TC1 as primary slave.
왘 Set the Send Data parameters to correspond with
the entries for Communication Buffer Sizes,
Output, in the MI4 Configurator.
왘 Set the Receive Data parameters to correspond
with the entries for Communication Buffer Sizes,
Input, in the MI4 Configurator.
These entries in the Topology Configurator and in the
MI4 Configurator must agree in order to
communicate via Suconet K.
To Next Page
Loading...
