Testing the project
17
05/01 AWB27-1302-GB
왘 Connect the MI4-111-KE1 with the PLC Suconet
interface via the ZB4-231-KB1 cable.
왘 Start the PLC and switch to the status display.
The values from the PLC will be shown in the MI4
display.
Testing the project You can use the left-hand potentiometer of the
PS4-141-MM1 to change the actual value within the
range 0 to 1023.
After pressing the marker bitIns key of the MI4 you
can enter a value between 0 and 255. Following
confirmation with the Enter key, the new setpoint
value will be assumed by the MI4 and transmitted to
the PLC where it is shown at output byte 0.
Expanding the project The following functions are supplemented:
Eight alarm texts can be accessed via input byte
IB 0 (input similator) of the PLC.
Keys 7 and 8 on the MI4-111-KE1 are used as
function keys with the following functions:
Key 7: Display event list
Key 8: Delete event list
Actual value: 0
Setpoint value: 0
To Next Page
Loading...
