Example for Touch
Operator Panel
34
05/01 AWB27-1302-GB
Select font and font size after clicking on the “Select
font” button.
왘 Confirm your entries with OK.
A labelled touch cell with macro functions is created
on the display. You can test the macro function later
on in conjunction with the PLC.
You can also adjust the size and position of a touch
cell with the mouse at a later time.
왘 Select the touch cell.
왘 Change the size via the the gripper on the edge of
the touch cell. The mouse pointer will be
displayed as a “double arrow” during the action.
왘 Move the touch cell by dragging it with the
pressed mouse button while the mouse arrow is
displayed as a “cross”.
Creating data fields Creating the numeric data field for the setpoint
value
왘 Set double font size via ‹ Project
➞
Select Font...›
or via the Select Font icon.
왘 Position the cursor at the location on the display
where you wish to show the setpoint value in
numeric form and select ‹ Edit
➞
Data Field Type
➞
Numeric / ASCII› or click on the Numeric Data
Fields icon.
Numeric data fields
The definition mask for numeric data fields will
appear.
To Next Page
Loading...
