Example for Touch
Operator Panel
42
05/01 AWB27-1302-GB
왘 After a successful syntax check, start code
generation and create a new make file.
왘 Under Generate
➞
Program Parameters
➞
Compiler enter the active marker range (0 to 100,
for example)
왘 Select Generate
➞
Generate All
Once the program code has been generated you can
transfer the program to the PLC under Test and
Commissioning.
왘 Connect the MI4-471-TC1 with the PLC Suconet
interface via the ZB4-231-KB1 cable.
왘 Start the PLC and switch to the status display.
The values from the PLC will be shown in the MI4
display.
To Next Page
Loading...
