Operation
40
12/03 AWB-C27-1293GB
Key functions depending on the operating mode
The functions are dependent on the operating mode.
Only the standard functions are described here.
These functions – with the exception of functions
available in configuration mode – can be modified,
deleted or extended in the MI4 Configurator using
the keyboard macro editor.
Configuration mode (CONFIG)
1
If you have programmed the Enter key by mistake, change
to configuration mode as follows:
On MI4 with touchscreen: With a finger of the left hand,
press the centre of the left half of the touchscreen. Keep
the finger on the touchscreen and switch the power supply
on. With a finger of the right hand, tap the right half of the
touchscreen once every second until configuration mode is
selected.
On MI4 without touchscreen: Keep any three keys pressed
at the same time and switch the 24 V power supply on.
Keep the keys pressed until the MI4 is in configuration
mode.
)
Some panels do not have a “Clear” key; the
corresponding function can, however, be called
up by simultaneously pressing the “←” and “→”
keys.
Enter
1
View the type and version of the
communication driver
Enter Pressed for 2 seconds:
Return to application mode, provided a
communication driver which is ready for
operation and a valid project have been
saved in the device (the key must be
pressed for two seconds).
To Next Page
Loading...
