Moffat Turbofan E35 - Trouble Shooting; The Oven Does Not Operate; Start; Fan Doesnt Operate; Steam Light Does Not Illuminate

-17-
Revision 7/F3512
© Moffat Ltd, January 2005
E35 Turbofan Ovens
5. TROUBLE SHOOTING
FAULT POSSIBLE CAUSE REMEDY
THE OVEN DOES NOT
OPERATE / START
The mains isolating switch on the
wall, circuit breaker or fuses are
“off” at the power board.
The power switch on the oven is
off (‘0’).
Incorrect electrical supply.
Oven circuit breaker tripped.
Power switch on unit faulty.
Turn on.
Turn switch to ‘I’ position.
Ensure electrical supply correct.
Identify fault.
Reset circuit breaker.
Replace.
(Refer service section 6.3.1)
FAN DOESN’T OPERATE Door not closed.
(Fan only operates when the
door is closed).
Door microswitch out of
adjustment.
Door microswitch faulty.
Fan motor faulty.
Wiring.
Fan timers.
Close door.
Adjust.
(Refer service section 6.4.1)
Replace.
(Refer service section 6.3.3)
Replace.
(Refer service section 6.3.21)
Check and tighten any loose
wiring.
Replace.
(Refer service section 6.3.11)
STEAM LIGHT DOES NOT
ILLUMINATE
Blown bulb. Replace bulb.
NO STEAM
(continued next page)
Water not turned on.
Blocked filter in water solenoid.
Nozzle blocked.
Check valve blocked/corroded.
Turn water on at isolating valve.
Clean filter.
Remove, clean or replace.
(Refer service section 6.3.16)
Remove check valve.
(Refer service section 6.3.15)
WARNING: ALL INSTALLATION AND SERVICE REPAIR WORK MUST BE CARRIED OUT BY
QUALIFIED PERSONS ONLY.