C-75 Installation Guide
17
Figure 0-5. Connect C-75 to network
4. Check the status LEDs on the device. If all LEDs glow green, then the device is operational and
connected to the server.
5. Log on to the server through SSH and run the get sensor list command.
You would see a list of all Mojo devices that are recognized by the server. Mojo One users can go to the
Devices tab in Mojo Wireless Manager and check whether the device is visible under the Devices tab.
The device is configured and ready to go operational.
Note: If the zero configuration is not successful, the device must be configured manually. Refer to
Manually
Configuring C-75
for details.
To Next Page
Loading...
