C-75 Installation Guide
22
5. Configure server discovery on the device.
6. Configure a static IP address on the device. For example: Untagged VLAN 192.168.2.x/24.
After completing this step you will lose the SSH connection.
7. Configure the LAN IP address in the range of 192.168.2.x/24 and again SSH to the address assigned
in step 6.
8. Check the configuration settings.
9. Remove the crossover connection to the computer and connect the Ethernet port to the local
switch.
Configure IPv6 settings
C-75 is IPv6 capable. Use the set ipv6 config command to configure advanced options such as DHCP settings,
auto negotiation, and manual configuration.
Enable auto negotiation to discover IP address automatically.
Enable DHCP settings to obtain addressing as well as more information, such as the DNS address
from DHCP server in the network.
Enable manual configuration to provide manual IPv6 address as well as IPv6 default gateway.
How to configure Communication Key or Passphrase
To configure the communication key or passphrase kindly refer to Appendix A: AP-Server Mutual
Authentication for further details.
To Next Page
Loading...
