Mojo C-75 - Setting Sensor Mode

C-75 Installation Guide
19
Figure 0-1 The set server discovery Command
Note: If IP address/ host name based discovery is being used and more than one server is present on the
network, then you must enter the IP address of the appropriate server.
Set Sensor Mode
The next step is to set the mode of the sensor. There are two possible modes:
 Sensor Mode: This is the default mode. In this mode, the device can be connected to a trunk port
(802.1Q capable) on a switch. The device then monitors multiple VLANs that are configured on that
trunk port and are chosen by the user. The wireless interface of the sensor is enabled. In this mode, a C-
75 can monitor up to 16 VLANs.
 ND Mode: This mode needs to be explicitly configured. In this mode, the device can be connected
to a trunk port (802.1Q capable) on a switch. It then monitors multiple VLANs that are configured on
that trunk port and are chosen by the user. The wireless interface of the ND is disabled. In this mode, a
C-75 functioning as a WIPS sensor can detect and monitor up to 100 VLANs.
Use the set mode command to set the device mode for C-75.
Figure 0-2 The set mode Command for C-75