Mojo C-75 - set Commands Reference

C-75 Installation Guide
24
Table 0-2. set Commands
set Commands
Command
Description
set erase
Sets the erase character to ^H.
set interface
Sets network interface properties such as auto negotiation, speed, and duplex
settings.
set ip config
Runs through the current VLAN and IP config wizard.
set server discovery
Sets the server discovery information.
set vlan config
Configures list of VLANs and their network settings to be monitored by ND.
set ipv6 config
Sets IPv6 network settings.
get vlan connectivity
Pings the specified VLAN other than the communication VLAN.
get model
Displays the AP model.
get antenna
Displays antenna configuration (internal/ external).
get route
Displays IP routing table entries.
get client logs
Gets client connection logs as it happens.
get wired trace
Performs packet capture on Ethernet interface(eth0) upto file size 5MB.
get ap status
Displays wireless profiles and associated clients.
get presence
notification
parameters
Displays the value of the presence notification parameters, that is, RSSI value in dbm,
time interval in seconds, and IP address or host name of the presence notification
server.
get admctl stats
Displays statistical information related to admission control of both the radios and a
list of the connected and admitted clients.