molex SST-DN4-PCU - Installation

To Next Page

To Previous Page

Hardware Reference Guide SST-DN4-PCU

Installation 21

Document Edition: 1.0, Document #: 715-0101, Template Edition: 1.1, Template #: QMS-06-045

Use, duplication or disclosure of this document or any of the information contained herein is subject to the restrictions on page ii of this document.

Installation

Chapter Sections:

• System Requirements

• Handling Precautions

• Installing the Card

• Connecting to a Network

Main Page

Preface3
Purpose of this Guide4
Using this Guide4
Conventions5
Style5
Terminology6
Special Notation7
Table of Contents9
Card Overview11
Warnings and Cautions12
Card Features13
Byte Ordering13
DN4 Compatibility Overview14
Hardware Description15
CAN Connector16
Leds18
Installation21
System Requirements22
Handling Precautions22
Installing the Card23
Connecting to a Network24
Connecting to a Devicenet Network24
Connecting to a CAN Network25
Hardware Register Details27
Introduction28
Card Configuration Space28
Resource Allocation30
DN4 Card Configuration Registers30
Host Register Layout30
Control Register32
Addrmatch Register33
Bank Address Register33
Banksize Register35
Hostirq Register36
Ledreg Register36
Debug Register37
Host Data Register (Familyid)37
Troubleshooting39
HLTH LED Is Red40
Memory Conflict41
Card Not Found41
General Troubleshooting41
Error Messages43
Introduction44
Familyid Messages44
Fatal Hardware Self-Test Flash Codes44
Technical Specifications45
Technical Specifications46
Loading Firmware49
Loading Firmware50
Verify Card Presence50
Check for Conflicting RAM51
Test Channel RAM52
Load and Start the Firmware Module53
Warranty and Support55
Warranty56
Reference Documents56
Technical Support56
Getting Help57
CE Compliance59
CE Compliance60

molex SST-DN4-PCU - Installation

Table of Contents