SST-DN4-PCU Hardware Reference Guide
2.1 System Requirements
To install and operate the card, the following system requirements must be met:
• An available PC v2.2 or v2.3 slot. The card will also operate in some PCI v2.1-compliant
systems. Refer to Section 1.4, DN4 Compatibility Overview, for more compatibility
details.
• If interrupts are required, you will need a physical interrupt.
2.2 Handling Precautions
The card contains components that are sensitive to electrostatic discharge (ESD). Do not touch it
without following these precautions:
Caution
• Always follow correct ESD procedures before handling the card.
We strongly recommend the use of a grounding wrist strap as a
standard handling practice.
• Never touch any of the card’s connectors or pins. Handle the card by
its edges or bracket.
• When the card is not in your computer, always store it in its protective
anti-static bag.
22 Installation
©2009 Molex Inc.Automation & Electrical Products, Integrated Products Division
Document Edition: 1.0, Document #: 715-0101, Template Edition: 1.1, Template #: QMS-06-045
Use, duplication or disclosure of this document or any of the information contained herein is subject to the restrictions on page ii of this document.
To Next Page
Loading...