Hardware Reference Guide SST-DN4-PCU
Troubleshooting 41
©2009 Molex Inc.Automation & Electrical Products, Integrated Products Division
Document Edition: 1.0, Document #: 715-0101, Template Edition: 1.1, Template #: QMS-06-045
Use, duplication or disclosure of this document or any of the information contained herein is subject to the restrictions on page ii of this document.
4.2 Memory Conflict
If a memory conflict is detected, examine the resource allocations in the operating system.
If the operating system does not manage resources, review the requirements of the other
hardware installed in the machine to select a non-conflicting memory window. If you continue
to experience difficulties, refer to Section 4.4,
General Troubleshooting.
4.3 Card Not Found
If a “card not found” message is displayed, check for memory I/O and IRQ conflicts. If you
continue to experience difficulties, refer to Section 4.4, General Troubleshooting.
4.4 General Troubleshooting
If you experience problems with the card:
1. Check the website at http://www.woodhead.com for technical notes and DeviceNet
release notes.
2. Check the FAQs on the website.
3. Refer to Section D.3, Technical Support.
To Next Page
Loading...