SST-DN4-PCU Hardware Reference Guide
E.1 CE Compliance
This device meets or exceeds the requirements of the following standard:
• EN 61326:1998 including amendments A1 and A2: - “Electrical equipment for
measurement, control and laboratory use - EMC requirements.
Warning
This is a Class A product. In a domestic environment this product may
cause radio interference in which case you may be required to take
adequate measures.
Caution
This equipment is neither designed for, nor intended for operation in
installations where it is subject to hazardous voltages and hazardous
currents.
Marking of this equipment with the symbol indicates compliance with European Council
Directive 89/336/EEC - The EMC Directive as amended by 92/31/EEC and 93/68/EEC.
Note
To maintain compliance with the limits and requirements of the EMC
Directive, it is required to use quality interfacing cables and connectors
when connecting to this device. Refer to the cable specifications in the
Hardware Guide for selection of cable types.
Note
The backplane voltage supply for this equipment must be delivered as
Separated Extra Low Voltage (SELV).
60 CE Compliance
©2009 Molex Inc.Automation & Electrical Products, Integrated Products Division
Document Edition: 1.0, Document #: 715-0101, Template Edition: 1.1, Template #: QMS-06-045
Use, duplication or disclosure of this document or any of the information contained herein is subject to the restrictions on page ii of this document.
To Previous Page
Loading...