EnDaL smart PC SOFTWARE – MONI LOG® ANALYZER
- 45 -
Note:
Please refer to the description in chapter 4.3.3 „Status and thresholds“
for the meaning of the individual setting fields.
Changing the synchronous interval & setting of alarm events:
The setting of the synchronous interval is made with the aid of the selection fields (Figure 34,
no. 1) “Synchronous interval” (in hours + minutes).
The input fields below (Figure 34, no. 2 u. 3) allow to parametrise the alarm events. By means of
the adjusted threshold values (partially, lower and upper threshold values are adjustable) alarm
events are saved, if an exceedance of or a falling below the threshold values is detected during
the measurement run. An activated “check marks” in front of the input fields activates the creation
of the alarm events. If alarm events have occurred, this is shown when actuating the status key
above the alarm-LED.
The settings are saved by clicking on “Transferring the configuration” (Figure 34, no. 4) and are
transferred to the device.
Deleting the memory:
The function “Deleting the memory” (see Figure 34, no. 5) deletes all data that are stored in the
EnDaL smart.
Attention!
Make sure that you have read out the data completely and that you have saved them
as *.esm-file before deleting them! Deleted data cannot be recovered!
To Next Page
Loading...