Contents
1. Brief description 1
2. Assembly 2
3. Electrical connection 3
4. Functions and operation description 6
4.1. Programming software PM-TOOL 7
5. Setting up the device 8
5.1. Switching on 8
5.2. Standard parameterisation (flat operation level) 8
Value assigment for triggering of the signal input
5.3. Programming interlock „RUN“ 12
Activation/Deactivation of the programming interlock or change into the professional level
respectively back into the flat operation level
5.4. Extended parameterisation (professional operation level) 12
5.4.1. Signal input parameter „INP“ 12
Value assigment for triggering of the signal input incl. linearisation
5.4.2. General device parameter „FCT“ 16
Higher device functions like Hold, Tara, min/max permanent, setpoint function
respectively nominal value function, average determination, brightness control,
as well as the control of the digital input and the keyboard configuration
5.4.3. Safety parameter „COD“ 21
Assignment of user and master code for locking or access to certain
parameters like e.g. analog output and alarms, etc.
5.4.4. Analog output parameter „Out“ 22
Analog output functions
5.4.5. Relay functions „rel“ 24
Parameter for the definition of the setpoints
5.4.6. Alarm parameter „AL1…AL4“ 27
Activator and dependencies of the alarms
5.4.7. Totaliser (Volume metering) „tot“ 29
Parameter for calculation of the sum function
6. Reset to factory settings 30
Reset of the parameter to the factory default settings
7. Alarms / Relays 31
Function principle of the switching outputs
8. Sensor alignment 33
Function diagram for sensors with existing trimming resistor
9. Technical data 34
10. Safety advices 36
11. Error elimination 37
To Next Page
Loading...
