montwill M2 - Analog Output Parameter Out

5. Setting up the device
22
Menu level Parameterisation level
Release/lock alarm parameters,
Default:
This parameter describes the user release/user lock of the alarm:
, only the range of value of the threshold values 1-4 can be changed.
- , the range of value and the alarm trigger can be changed.
- , all alarm parameters are released.
- , all alarm parameters are locked.
Back to menu group level,
With [P] the selection is confirmed and the device changes into menu group level
„ .
Menu group level
5.4.4. Analog output parameters
Menu level
Menu level Parameterisation level
Selection reference analog output,
Default:
The analog output signal can refer to different functions, in detail this are the
current measurand, min/max-value or totaliser function/sum-function, the sliding
average value, the constant value or the difference between the current value and
the constant value. If was selected, the signal of the analog output will be
hold and processed just after deactivation of . With [P] the selection is
confirmed and the device changes into menu level.