5. Setting up the device
28
Menu level Parameterisation level
Threshold values / limits,
Default:
This limit value defines the threshold, that leads to an activation / deactivation of
the alarm.
Hysteresis for threshold values,
Default:
The difference to the threshold value that causes the delay of the actuation of the
alarm, is defined by the hysteresis.
Function for threshold value exceedance/undercut,
Default:
The limit value undercut can be selected with (LOW = lower limit value) and
limit value exceedance can be selected with (HIGH = upper limit value). If e.g.
limit value 1 is on a switching threshold of 100 and occupied with function , the
alarm will be activated by reaching the threshold. If the limit value is allocated to
, an alarm will be activated by undercut of the threshold.
Switching-on delay,
Default:
For limit value 1 one can preset a delayed switching-on of 0-100 seconds.
Switching-off delay,
Default:
For limit value 1 one can preset a delayed switching-off of 0-100 seconds.
Back to menu group level, :
With [P] the selection is confirmed and the device changes into menu group level
.
The same applies to to .
To Next Page
Loading...
