05/06
•
45
ROUTINE LUBRICATION SCHEDULE
Please note that the following maintenance intervals apply for normal operating
conditions only. Intervals are hours of operations based on 8 hours per day, 5 days
per week. If your operating conditions are difficult, adjust the specified intervals
accordingly.
8 hours
40 hours
1) Wheel Axle
1)
2) Top feed wheel bearings (2 places)
3) Bottom feed wheel bearings (2 places)
4) Yoke cylinder pins (4 places)
X
5) Yoke pivot pin (2 places)
X
6) Clutch (4 places)
1)
7) Discharge chute swivel and crank handle (3 places)
X
8) Drum bearing grease slingers (4 places)
2,3)
X
X = 1 SHOT OF GREASE
Use only EP-2 rated grease.
See Manual supplied with your machine.
2) Only grease zert above aluminum grease seals need to be greased.
3) Use same grease that is in the bearing.
To Next Page
Loading...