Mostek z80 - D-Dump Command; Description of D Command

3-19
3.20 D-DUMP COMMAND.
FORMAT:
,Q s,f (CR)
3.21 DESCRIPTION, D CQ'<1MAND
The DUMP coomand is used to save the block of Target memory starting at "s"
through "f" on floppy diskette in a binary file. When the (CR) is received,
the System will pranpt the user to enter the desired file name. The System
will then check if the file exists and and if the user specifies will erase
the file and create a new file.
If a file name has been previously specified with the D, G, or V commands or
when initially loading AIMZ80, that file name has been retained. When a
file name is requested, type only (CR) and the old file name will be used.
3.22 EXAMPLE, D COMMAND
,Q 0 ,F (CR) < dump address 0 thru 0FH
ENTER TARGET PROGRAM FILE NAME OR (CR) --> DKl:TEST(CR)
DK0:TEST
.BIN[l],ALREADY EXISTS
ERASE? Y (CR) < "TEST" should have already been on the disk
DO YOU WISH TO DUMP THE MAP FILE? (Y OR N) -- > Y (CR)
ENTER MAP FILE NAME OR (CR) -->lCR) < use default name, which
this time is "TEST"
DK0:TEST .MAP[l] ,ALREADY EXIS'rS
ERASE? r1 CR)
,
< the machine does the rest