Mostek z80 - G-Get Command; Description of G Command

3-24
3.32 G-GET COMMAND
FORMAT:
,G [file] (CR)
3.33 DESCRIPI'ION, G C~
The G command is used to load a binary file into Target RAM. For long files
(greater than 16k) there may be some delay in loading the file. The G
con~and may be used any time the Target system is not executing the Target
program.
If a file name has been previously specified with the D, G, or V commands,
or when initially loading AIMZ80, then that file name has been retained.
When a file name is requested, type only (CR) and the old file name will be
used.
3.34
EXAMPLES, G COMrvlAND
,E:. 0,i",AA{CR)
,~ 0,F{CR)
0000 AA AA AA AA
< destroy old program by overwriting
< look at it
AA AA AA AA AA AA AA AA AA AA AA AA
,~ DKl:TEST{CR) < reload the program
,~ 0,F{CR) < look at it again
0000 3E 00 3C 3C 2F 3C 3C 2F 18 F6 00 00 00 00 00 00
,