Mostek z80 - Preparation Steps; Initialization Process; Error Handling

3-3
Target programs may be created, edited, assembled and linked usi03 the
MOSTEK disk-based development system and then loaded into Target memory and
inunediately
tested. Loading a Target program at initialization is optional
since it may be desired to debug a short program which is entered using the
M carunand. When poweri03 up the System, the diskettes should NOT be
installed. The developnent system should be powered up first, then the
Target system. After all power is on the systan is booted up as normal.
When powering down the reverse sequence should be taken.
3.3 INITIALIZATION
After the system is powered up and FLP-80DOS is operati03 AIMZ80.BIN may
be loaded and executed using the implied run coounand. An optional File
name may also be entered to automatically load the Target program. The
format for initializing AIMZ80 follows.
$AIMZ80 [file name] (CR)
AIMZ80 VERSION 1.0
,
The AIMZ80 program will be loaded and executed and the sign on message and
prompt
character will be printed. If the file AIMZ80.MAP exists then it
also will be loaded to specify the system configuration and if a Target
program is specified it will be loaded into Target Inemory space.
3.4 ERRORS
If an error is encountered during initialization, an error message will be
printed notiI'B the error, and the corrunand mode will be entered as normal.
Error messages may also be printed during operation if the system fails to
function as expected, or if the operator attanpts an operation which is not
allowed or does not make sense. Table 1 summarizes the possible error
messages and explains the probable cause.