Mostek z80 - V-Verify Command; Description of V Command

3-48
3.65 V-VERIFY CavJMAND
FORMAT:
,V [file] (CR)
3.66 DESCRIPTION, V COMMAND
The V command is used to verify the contents of Target memory against a
binary file on disk. If any locations do not compare, the hexadecimal
address, data and expected data are printed.
If a file name has been previously specified with the D, G, or V commands,
or when initially loading AIMZ80, then that file name has been retained.
When a file name is requested, type only (CR) and the old file name will be
used.
3.67 EXAMPLE, V COMMAND
,Q TEST(CR)
,~ .ti
CR
)
0000 3E1CR)
0001
00 M(CR)
0002 3C1CR)
0003 3C M(CR)
0004 2F1CR)
0005 3C 55 (CR)
0006 3C1CR)
0007 2F 55 (CR)
0008 18 •
< get the test program
< change some locations
,V lCR) < verify - expect the errors just introduced
*** ERROR 6D TARGET MEMORY COMPARE ***
0001 M 00