MoTeC C125 Track Kits 15
Installing the OBD-II To Display Loom
The OBD-II loom is a terminated adapter that joins the C125 terminated loom
(#62204) to the standard on-board diagnostics port on most road cars 2007 or
later.
There is no standard location for the OBD-II socket in a road car, so you will
have to search your vehicle to find its location. The most common place is in
the driver’s foot well, under the dash panel. In some instances it is directly
accessible, other times you may need to remove a covering panel.
Installation method – if C125 came pre-configured
1. Plug in the C125, buttons and GPS. DO NOT connect the OBD-II To
Display Loom at this stage.
2. Plug the cigarette lighter power adapter into a spare power supply socket.
3. Press and hold the red button on the button loom for at least 5 seconds. If
correctly configured, “OBD-II” will display on the C125. NOTE: If “OBD-II”
does not display, do not plug in the OBD-II To Display Loom and follow the
NOT pre-configured instructions.
4. Plug the 4 pin DTMF connector into the connector labelled ECU.
5. Find the OBD-II connector and plug in the mating connector.
6. Start the car. Installation should now be complete.
Installation method – if C125 is NOT pre-configured
1. Plug in the C125, buttons and GPS. DO NOT connect the OBD-II To
Display Loom at this stage.
2. Plug the cigarette lighter power adapter into a spare power supply socket
3. Connect a laptop to the C125 using the provided Ethernet lead
4. Start up C125 Dash Manager
5. Select Tools > Connection settings in C125 Dash Manager, then select
Add
6. Select the Search button
7. Highlight the device displayed in the connected device window, and select
the Select button
8. Select OK on the new IP screen
9. Select OK on the Connection settings screen
10. Select File > New
11. Select C125 OBD2 configuration
To Next Page
Loading...
Need help?
General