EasyManua.ls Logo

Motec Systems C125 - Power Supply; Operating Temperature

Motec Systems C125
93 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
58 Appendices MoTeC
Internal Sensors
3-axis accelerometer, detection range: +/- 5G
Dash temperature sensor
Sensor supply voltage
Battery voltage
Communications
2 configurable CAN buses, with individually programmable CAN bus speeds.
One can be used as RS232 Receive.
o Maximum data range 1 Mbit/sec
o Recommended terminating impedance 100 ohm
o Configurable as either CAN or RS232
2 RS232 ports, one with transmit and receive, one with receive only
Physical
Size: 134.5 x 103.9 x 20.2 mm excluding connector
Weight 360 g
1 x 34 pin waterproof connector
Power Supply
Operating voltage: 6 to 32 volt DC
Operating current: 0.5 ampere typical at 14 volt (excluding sensor currents)
Reverse Battery protection
Battery Transient protection
Operating Temperature
Internal: -20 °C to 70 °C (above 60 °C maximum backlight brightness
progressively reduced)
Typical ambient temperature range in free air: -20 to 55 °C
Sensor Supply Current
5 V Sensor supply: 0.25 ampere maximum
8 V Sensor supply: 0.25 ampere maximum

Table of Contents