Motic AE2000 - Electrical; Care and Maintenance; Lenses and Filters; Cleaning of Painted or Plastic Components

25
2. Electrical
Problem Possible Cause
Lamp does not light
Power supply not plugged in
Lamp not installed
User left more than 15 minutes under auto mode
Lamp burnt out
Inadequate brightness Specified lamp not being used
Lamp blows out immediately Specified lamp not being used
Lamp flickers
Connectors are not securely connected
Lamp near end of service life
Lamp not securely plugged into socket
VII. Care and Maintenance
1. Lenses and Filters
y
To clean lens surfaces or filters, first remove dust using an air blower. If dust still persists, use a soft /
clean brush or gauze.
y A soft gauze or lens tissue lightly moistened with the mixture of alcohol and ether ( ratio: alcohol : 3 and
ether: 7) should only be used to remove grease or fingerprints.
y Use the mixture of alcohol and ether ( ratio : alcohol : 3 and ether: 7) to clean immersion oil.
y Use the mixture of alcohol and ether ( ratio : alcohol : 3 and ether: 7) only to remove immersion oil from
objective lenses.
y Because the mixture of alcohol and ether ( ratio : alcohol : 3 and ether: 7) is highly flammable, be careful
handling around open flame.
y Do not use same area of gauze or lens tissue to wipe more than once.
2. Cleaning of Painted or Plastic Components
y
Do not use organic solvents (thinners, alcohol, ether, etc.). Doing so could result in discolouration or in
the peeling of paint.
y For stubborn dirt, moisten a piece of gauze with diluted detergent and wipe clean.
y For plastic components, only moisten a piece of gauze with water and wipe clean.