Option Actions
Emergency Call with Hot Mic Speak into the microphone.
NOTE:
The Hot Mic applies to the first
voice transmission from your ra-
dio during the Emergency call. For
subsequent transmissions in the
same Emergency call, you must
press the PTT button.
3 To exit Emergency Call, see Exiting Emergency Operation
on page 55.
9.4
Exiting Emergency Operation
If an Emergency operation is triggered on your radio, the dispatch console or radios configured
as Supervisor can exit the Emergency operation and cancel emergency mode of other radios. The
dispatch console must be programmed to use this feature.
Procedure:
1 To exit Emergency, perform one of the following:
Option Actions
Exiting Emergency Oper-
ation
a From the Home screen, swipe down the Status Bar.
b Tap Cancel and confirm the action by tapping Yes.
Exiting Emergency as
Supervisor (Trunking On-
ly)
• If the emergency mode is initiated by other radios, press
and hold the 1-Dot (Side Middle) button, and press the
Emergency button.
• If the emergency mode is initiated by the Supervisor, per-
form one of the following:
• Press and hold the Emergency button.
• Press and hold the 1-Dot (Side Middle) button, and
press the Emergency button.
• Wait for console to clear emergency.
NOTE: The combinations of the following buttons
are supported in your radio:
• Radio 1-Dot (Side Middle) and Top (Orange)
buttons.
• Radio 1-Dot (Side Middle) and accessory Top (Orange)
buttons.
• Accessory 1-Dot Button and radio Top (Orange) button.
• Accessory 1-Dot Button and accessory Orange button.
Exiting Emergency Via
Console (Trunking Only)
Radios configured as console only are not able to cancel
emergency mode from the radio. The dispatch operator or
supervisor must clear the emergency. Contact your system
administrator for more information.
MN009207A01-AA
Chapter 9 : Emergency Operation
55
To Next Page
Loading...
Need help?
General
