8-149
AP51xx>admin(system.aap-setup)>show
Description:
Displays the access point’s Adaptive AP configuration.
Syntax:
Example:
admin(system.aap-setup)>show
Auto Discovery Mode : disable
Switch Interface : lan1
Switch Name : greg
Static IP Port : 24576
Static IP Address :
IP Address 1 : 0.0.0.0
IP Address 2 : 0.0.0.0
IP Address 3 : 0.0.0.0
IP Address 4 : 0.0.0.0
IP Address 5 : 0.0.0.0
IP Address 6 : 0.0.0.0
IP Address 7 : 0.0.0.0
IP Address 8 : 0.0.0.0
IP Address 9 : 0.0.0.0
IP Address 10 : 0.0.0.0
IP Address 11 : 0.0.0.0
IP Address 12 : 0.0.0.0
Tunnel to Switch : disable
AC Keepalive : 5
Current Switch : 157.235.22.11
AP Run Mode : TBD
AP Run State : AAP not adopted
admin(system.aap-setup)>
For information on configuring adaptive AP using the applet (GUI), see Adaptive AP Setup on page 4-6.
For an overview of adaptive AP functionality and its implications, see Adaptive AP on page 10-1.
show Displays the access point’s Adaptive AP configuration.
NOTE The access point CLI is only the only AP interface that displays the adaptive AP’s adoption status and AP
run state. This information does not appear within the Adaptive AP Setup screen.
To Next Page
Loading...
Need help?
General
