Chapter 1 Introduction
This manual covers the installation procedures for ASTRO XTL 1500 mobile and accessories
required to complete the radio system. The radio system consists of a control head, radio, antenna,
microphone, cabling, and accessories.
1.1 Mobile Radio Description
1.1.1 Dimensions
Figure 1-1 and Figure 1-2 show the basic dimensions of the dash mount brick trunnion XTL 1500
radio.
When installing the radio, make sure to plan the installation carefully and leave additional room in the
rear of the radio for cabling and accessory connections; in the front of the radio for access, controls;
and to the sides of the radio so that you may access and install the trunnion wing screws.
NOTE: The rear accessory connector adds 0.75 in. to the overall length.
Figure 1-1. Front View of Dash Mount Brick
Trunnion Figure 1-2. Side View of Dash Mount Brick Trunnion
7.3"
8.5"
9.7"
2.0"
3.3"
To Next Page
Loading...
Need help?
General