1 - 8 ET1 Enterprise Tablet User Guide
3. Touch OK.
4. Wait for the ET1 to power off completely.
5. Press thumb against the side of the ET1 and battery. Using the index and middle fingers, move the battery
release latch toward thumb.
6. Pull the battery out of the battery compartment.
7. Lift the access door.
Figure 1-5
Lift Access Door
8. Remove the microSD card from the card holder.
9. Align the replacement microSD card with the card holder. Ensure that the contacts on the card are facing
down and toward the card holder.
10. Insert the microSD card into the card holder.
Figure 1-6
Insert microSD Card
11. Close the access door.
To Next Page
Loading...
