vi Product Safety and RF Exposure
• Trunk lid installations are limited to vehicles with clearly defined flat trunk lids, and in some
cases, to specific terminal models and antennas. See the Radio (Terminal) Installation Manual
for specific information on how and where to install specific types of approved antennas to
facilitate recommended operating distances to all potentially exposed persons.
• Use only Motorola-approved supplied antenna or a Motorola approved replacement
antenna. Unauthorised antennas, modifications, or attachments could damage the terminal and
may result in non-compliance with RF Safety Standards.
Approved Accessories
• This terminal has been tested and meets the RF Safety Standards when used with the Motorola
accessories supplied or designated for this product. Use of other accessories may result in non-
compliance with RF Safety Standards.
• For a list of Motorola approved antennas, please see your dealer or local Motorola contact. Your
nearest dealer can be found at the following web site:
http://www.motorola.com/governmentandenterprise
Additional Information
• For additional information on exposure requirements or other training information, visit
http://www.motorola.com/rfhealth
Compliance and Control Guidelines and Operating Instructions for Mobile
Two-Way Terminals Installed as Fixed Site Control Stations
If mobile terminal equipment is installed at a fixed location and operated as a control station or as a
fixed unit, the antenna installation must comply with the following requirements in order to ensure
optimal performance and compliance with the RF energy exposure limits in the standards and
guidelines listed on previous page:
• The antenna should be mounted outside the building on the roof or a tower if at all possible.
• As with all fixed site antenna installations, it is the responsibility of the licensee to manage the
site in accordance with applicable regulatory requirements and may require additional
compliance actions such as site survey measurements, signage, and site access restrictions in
order to insure that exposure limits are not exceeded.
Electromagnetic Interference/Compatibility
Note: Nearly every electronic device is susceptible to electromagnetic interference (EMI) if
inadequately shielded, designed or otherwise configured for electromagnetic compatibility. It may be
necessary to conduct compatibility testing to determine if any electronic equipment used in or
around vehicles or near fixed site antenna is sensitive to external RF energy or if any procedures
need to be followed to eliminate or mitigate the potential for interaction between the terminal
transmitter and the equipment or device.
To Next Page
Loading...
Need help?
General
